Ohio Steel 34601 20 Cu Ft Welded Steel Dump Cart - Manual (Page 2)

and hitch and center.
Add washer, spacer, wheel and •
another washer in that order
to each end of the axle.
Insert cotter pins •
through holes in
axle and lock in place
by spreading ends.
5/16" keps nuts to attach undercarrige as shown.
• Use twelve 5/16" x 3/4" pan head bolts and
pan head bolts and 5/16" keps nuts.
• Attach the front support using four 5/16" x 3/4"
the front support.
• Position Cart to add the undercarriage and
• cordless drill
• pliers
• large blade screw driver
• 1/2" wrench
TOOLS REQUIRED
ASSEMBLY - SEE FIGURE 1.
SAFETY RULES
DO NOT CARRY PASSENGERS IN THE CART. •
• LOAD CAPACITY IS 1500 POUNDS
• BECAREFUL ON STEEP GRADES.
• LODS OR OVER ROUGH TERRAIN.
• USE LOW SPEED - 5MPH-WHEN PULLING HEAVY
•
and corrosion.
• Keep cart clean and dry to prevent rust
• Grease wheels regularly.
14 p.s.i. is recommended.
• Check tire pressure regularly.
MAINTENANCE
DO NOT TOW THIS CART ON PUBLIC ROADS.
ASSEMBLY - SEE FIGURE 2.
Slide axle through the axle holder •
OPERATION
With cart attached to tractor, remove tailgate, •
and then pull back on latch bar. Cart body will
tilt backwards, dumping contents. Once empty,
replace tail gate, then pull cart body back down
until it latches.
Follow all operating instructions in •
tractors user manual.
18
Figure 2.
19
21
19
17
12A
32
•
Figure 3.
ASSEMBLY - SEE FIGURE 3.
Turn cart upright on wheels. •
Slide tail gate into position. •
Assembly is complete.
2
25
Figure 1.
11
9
25N