Northern Airborne Technology AMU50-001 - Manual (Page 13)

AMU50-001 Audio Management Unit
SM76 Installation and Operation Manual
Section 2 Rev: 1.04
Issue 1 Page 2-1
ENG-FORM: 805-0120.DOT
CONFIDENTIAL AND PROPRIETARY TO NORTHERN AIRBORNE TECHNOLOGY LTD.
Section 2 Installation
2.1 Introduction
Information in this section consists of unpacking and inspection procedures, installation procedures, post-
installation checks and installation drawings for the AMU50-001 Audio Management Unit (AMU50).
Review all notes, warnings and cautions.
2.2 Unpacking and Inspection
Unpack the equipment carefully and locate the warranty card. Inspect the unit visually for damage due to
shipping and report all such claims immediately to the carrier involved. Check that all items listed below
are present before proceeding and report any shortage immediately to your supplier:
- Warranty Card
- Certificate of Conformity or Release Certification
2.2.1 Warranty
All Northern Airborne Technology Ltd. products are warranted for 2 years from date of installation by an
authorized dealer, to be free of defects in workmanship or performance. This warranty covers all materials
and labour, but is exclusive of any transport to deliver the defective unit to and from Northern Airborne
Technology or its designated warranty repair center, or any labour to remove or re-install the defective
unit in the aircraft. Contact Northern Airborne Technology for any questions regarding this warranty, its
applicability to your units and/or for return authorization. Northern Airborne Technology is the final
arbitrator concerning warranty administration. Units which have been physically damaged, burned,
immersed in water or otherwise abused beyond the scope of normal use will not be considered for
warranty. WARRANTY IS VOID UNLESS THE PRODUCT IS INSTALLED BY AN AUTHORIZED
Northern Airborne Technology DEALER. Product for which a warranty card is not returned shall be
warranted from date of manufacture.
2.3 Continued Airworthiness
Maintenance of the AMU50-001 Audio Management Unit is ‘on condition’ only. Periodic maintenance of
this product is not required.
2.4 Installation Procedures
2.4.1 Warnings
WARNING:
High volume settings can cause hearing damage.
Set the headset volume control to the minimum volume setting prior to
conducting tests, and slowly increase the headset volume to a
comfortable listening level.