Northern Airborne Technology CC250 - Manual (Page 18)

CC450-0V2 Communications Controller
Installation and Operation Manual
2.6.4
Jumper JP101
Jumper JP101
Position
1-2 Normal Position
For correct operation, this jumper must be in the
1-2 position. This diagram is included to ensure
that the installer can replace the jumper if it is
accidentally dislodged.
2.6.5 Final Checks
If any preset requires adjustment, be sure this is carried out before the aircraft leaves, and that the unit
and its mating connector are secured before departure. Make all required log book entries, electrical
load, weight and balance amendments and other paperwork as required by your local regulatory agency.
2.7 Accessories Required But Not Supplied
The CC450-IKC kit consists of one D15SL-IKC, one D37SL-IKC, and one CC450-DMY. The contents of
each of these kits are listed below.
NAT Part #: D15SL-IKC consists of:
Quantity Description NAT Part #
1 D-min 15 Socket Housing 20-21-015
15 MS Crimp Socket 20-26-901
1* Jack Screw Set 20-27-002
1* Lock Clip Set 20-27-004
1 15 Pin Connector Hood 20-29-015
NAT Part #: D37SL-IKC consists of:
Quantity Description NAT Part #
1 D-min 37 Socket Housing 20-21-037
37 MS Crimp Socket 20-26-901
1* Jack Screw Set 20-27-002
1* Lock Clip Set 20-27-004
1 37 Pin Connector Hood 20-29-038
NAT Part #: CC450-DMY is a fully assembled Dummy Load that allows operation to continue if the
CC450-0V2 is removed for service. It consists of:
Quantity Description NAT Part #
1 D-sub plug, Solder cup 20-10-037
1 Hood, D-sub, plastic 20-29-038
1* Jack Screw Set 20-27-002
* Use as required.
Page 2-8 Issue 1 Section 2 Rev: 1.00
ENG-FORM: 805-0114.DOT
CONFIDENTIAL AND PROPRIETARY TO NORTHERN AIRBORNE TECHNOLOGY LTD.