Northern Airborne Technology CC250 - Manual (Page 11)

CC450-0V2 Communications Controller
Installation and Operation Manual
Section 2 Installation
2.1 Introduction
Information in this section consists of unpacking and inspection procedures, installation procedures, post-
installation checks and installation drawings. Review all notes, warnings and cautions before installation.
2.2 Unpacking and Inspection
Unpack the equipment carefully and locate the warranty card. Inspect the unit visually for damage due to
shipping and report all such claims immediately to the carrier involved. Check that all items listed below
are present before proceeding and report any shortage immediately to your supplier:
- Warranty Card
- Operators Manual
- Certificate of Conformity or Release Certification
2.2.1 Warranty
Complete the warranty card information and send it to NAT Ltd. when installation is complete. If you fail
to complete the warranty card, the warranty will be activated on shipment date from NAT Ltd.
Note: An appropriately rated facility, e.g. Certified Aircraft Repair Station, shall install this
equipment in accordance with applicable regulations. NAT Ltd’s. warranty is not valid unless
an authorized NAT Ltd. Dealer installs the equipment. Failure to follow any of the installation
instructions, or installation by a non-certified individual or agency will void the warranty, and
may result in a non-airworthy installation.
2.3 Continued Airworthiness
Maintenance of the CC450-0V2 Communications Controller is ‘on condition’ only. Periodic maintenance
of this product is not required.
2.4 Installation Procedures
2.4.1 Warnings
WARNING:
High volume settings can cause hearing damage.
Set the headset volume control to the minimum volume setting prior to
conducting audio tests, and slowly increase the headset volume to a
comfortable listening level.
Section 2 Rev: 1.00 Issue 1 Page 2-1
ENG-FORM: 805-0114.DOT
CONFIDENTIAL AND PROPRIETARY TO NORTHERN AIRBORNE TECHNOLOGY LTD.