Denon DRA-397 - Manual (Page 15)

Operation Operation
12
ENGLISH
Switching the brightness of the display
Press [DIMMER] .
The brightness of the display can be adjusted in three steps. The
display can also be turned off.
Checking the currently playing program source,
etc.
Press STATUS .
• The current program source and various settings are indicated on
the display.
This mode reproduces the sound with extremely high quality. The
display that could affect the audio signals are turned “OFF”.
Selecting the play mode (PURE DIRECT)
Press PURE DIRECT .
Use to set the level.Can be adjusted within the range of –10 dB to +10 dB.2Press to select “TONE DEFEAT ON”.Adjusting the speaker volumePress to select the speaker.The settable speaker switches each time this button is pressed.Use to set the level.
Can be adjusted within the range of –10 dB to +10 dB.
2
Press to select “TONE DEFEAT ON”.
Adjusting the speaker volume
Press to select the speaker.
The settable speaker switches each time this button is pressed.
Use to adjust the volume.
Can be adjusted within the range of –12 dB to +12 dB.
1
2
Setting the tone control
Press to select “BASS” or
“TREBLE”.
1
¢ Adjusting the tone
¢ When you do not want to adjust the tone
Press to select “LOUDNESS ON”.
¢ When listening with the volume turned low
Press [VIDEO SELECT] until the desired image appears
on the display.
Combining the currently playing sound with the
desired image (VIDEO SELECT function)
• To cancel, press [VIDEO SELECT] to select “SOURCE”.
• The video source selected with the video select function is stored in
the memory for the different input sources.
ENGLISH
Listening to the radio
Hold •> and press .
• The unit automatically begins searching for FM broadcast
stations.
When the first FM broadcast station is found, that station is
stored in the preset memory at channel A1.
Subsequent stations are automatically stored in order at preset
channels A1 to A8, B1 to B8, C1 to C8, D1 to D8, E1 to E8, F1 to
F8 and G1 to G8 for a maximum of 56 stations.
Channel A1 is tuned in after the auto preset memory operation is
completed.
Auto preset memory
This unit is equipped with a function for automatically searching for
FM broadcast stations and storing them in the preset memory.
• If an FM station cannot be preset automatically due to poor
reception, use the “Manual tuning” operation to tune in the station,
then preset it using the manual “Preset memory” operation.
• To interrupt this function, press .
¢ Default settings
Auto tuner presets
A1 ~ A8
87.5 / 89.1 / 98.1 / 107.9 / 90.1 / 90.1 / 90.1 /
90.1 MHz
B1 ~ B8
520 / 600 / 1000 / 1400 / 1500 / 1710 kHz,
90.1 / 90.1 MHz
C1 ~ C8 90.1 MHz
D1 ~ D8 90.1 MHz
E1 ~ E8 90.1 MHz
F1 ~ F8 90.1 MHz
G1 ~ G8 90.1 MHz
Press and set the DRA-397’s power
to the standby mode.
1
2
Check that the remote control unit is set to “A”.