Dolby Laboratories DVD/VCR Combo - Manual (Page 34)

- 34 -
Video Output
1. Press the SETUP button.
2. Use the cursor or button to select Video, then press the ENTER button.
3. Use the cursor or button to select Video Output, then press the ENTER button.
4. Use the cursor or button to shift and select the signal, then press the ENTER button.
5. To exit the FUNCTION SETUP MENU and return to the normal screen, press the RETURN button.
Attention :
Always set Video Output in CVBS, otherwise, the picture on the TV may be distorted. If this occurs, and you cannot
see the screen, follow these instructions:
1. Change FUNCTION to DVD mode.
2. Open the DVD door.
3. Press the SETUP, , ENTER, , ENTER, , ENTER & RETURN buttons.
(continued on next page) (continued on next page) (continued on next page) (continued on next page) (continued on next page)
Customizing the Function Settings
Brightness
1. Press the SETUP button.
2. Use the cursor or button to select Video, then press the ENTER button.
3. Use the cursor or button to select Brightness, and then press the ENTER button.
4. Use the cursor or button to shift and select the Off/On, then press the ENTER button.
5. If you want to exit the SETUP MENU and return to the normal screen, press the RETURN button.
Note:
• Actual effect on pictures will vary depending on the TV.
On : Picture will be brighter to clarify details.
Off : Picture will have deepened colors.
Note:
The RGB option is ONLY useful for use in Europe, and should not be selected.