Dolby Laboratories DVD/VCR Combo - Manual (Page 11)

- 11 -
Connections
(continued to next page) (continued to next page) (continued to next page) (continued to next page) (continued to next page)
1. Connecting to your TV
The Unit can be connected to your TV in several different ways, depending on the design of your TV.
1. Connect the TV antenna (coaxial cable) to the input jack on the unit.
2. Attach one end of the supplied coaxial cable to the output jack on the unit, and the other end of the cable to the
input jack on your TV.
Alternate Connections:
1. If your TV has Audio/Video inputs, you can also connect the unit to your TV using the supplied Audio/Video cord.
2. If your TV is equipped with an S-Video input, you can utilize the S-Video jack to connect the unit to your TV with
an S-Video cord (not supplied) instead of the yellow video cable. Please note that the S-Video and coaxial cable
connection will only carry the video signal from DVD playback. VCR playback will still require you to use the coaxial
cable connection.
To Wall Outlet
When you connect this system
to your TV, be sure to turn off
the power and unplug both
units from the wall outlet before
making any connections.
S-Video cable (not supplied)
Audio/Video cable
(supplied)
(Red)
(White)
(Yellow)
(Red)
(White)
(Yellow)
To Audio IN
To Video IN
Coaxial cable
(supplied)
CATV or
ANTENNA
Coaxial cable
(not supplied)
ANTENNA IN
(antenna or cable input)
AM
LO O P
AN T.
FM A NT.
3 00 ( ) Ω
IN
O UT
V HF/UH F/
CATV
AC R
L
AUDIO
V IDE O
R
L
AUDIO
VIDEO
TV OUT
Note:
• When playback DVD via coaxial cable to TV alone, there will be no audio output from the TV. i.e. Sound comes
from 5 speakers plus the subwoofer only.