Nevion 3GHD256256L - Manual (Page 14)

3GHD256256L / SD256256L Rev. E
nevion.com | 14
3.4.3 Status LEDs and reset button
There are 4 LEDs on the front side of the Multicon VX-MOD card, and a reset button on the
rear side.
Status LEDs
The LEDs indicate the following:
Diode Red LED Yellow LED Green LED No light
Status Card error. Not applicable. Overall status of
the card is OK Card has no
power, or is not
inserted correctly.
Eth Not applicable. Full duplex
connection. Half duplex
connection. No Ethernet link
established; check
cable.
Warn Abnormal
situation: no
functional error,
but a situation that
requires attention. Not applicable. Normal situation. Not applicable.
Load High load 4 on the
μController. May
occur during
system start up
and software
reconfigurations /
upgrades.
Medium load on
the μController. Low or normal load
on the μController. Not applicable.
4 Red LED means 100% load on the Multicon. This may occur for intervals up to approximately 20
seconds. Longer periods may indicate that there is something wrong with the Multicon.