Nevion CP-TOUCH - Manual (Page 11)

CP-TOUCH Rev. A
nevion.com | 11
4.3 Panel Group Setup
On the back of each control panel there is a DIP-Switch block used for putting a control
panel into panel groups. Panel group is used for mapping a control panel configuration file
to a panel. If several control panels should have the same functionality, just put them into
the same panel group. Every changes made to the control panel configuration file will be
applied to all the control panels in the same panel group. You may also put all control
panels into unique groups and apply the same configuration file the each group.
You may only include same type of control panels in the same panel group!
The drawing below shows a typical system setup:
Figure 8: Panel Group setup