Nevion CP-TOUCH - Manual (Page 10)

CP-TOUCH Rev. A
nevion.com | 10
4.2 Ethernet setup
It is recommended to connect the router system and control panels on a separate Ethernet
to prevent any interference from other Ethernet devices and to keep the load on the
network to a minimum. This will give the best system performance.
Every unit must have a unique IP address on the Ethernet LAN.
The drawing below shows a typical system setup:
Figure 7: Ethernet setup
Ethernet setup must be done with the Nevion Configurator software package,
which is supplied together with any of the CPs or routers.
If using managed Ethernet switch; set all ports to panels and routers to auto
negotiation.