Nevion PGM-HD-2x1-PB - Manual (Page 22)

PGM-HD-2x1-PB Rev. B
nevion.com | 22
6 RS422 commands
6.1 FLP4.0 required commands
Block Blk
#
Commands Example Response Control
- - ? ? product name\
SW rev n.m\
FW rev r.s\
protocol ver 4.0\ Hello command.
Note 1: No other commands will be
available until the card has received this
hello.
Note 2: This command will also enable
checksums.
Note 3: Cards are designed to be hot-
swappable. To sync with the start of a
new command, the cards will wait for a
character before looking for a valid
command.
conf 0 - conf 0 *too long to list* Configuration settings
Retrieves the card's configurable settings.
Each addressable block is represented by
a single line. Dynamic status may be
included in response, but is usually
reported in info only.
- - info info *too long to list* Dynamic status info
Blocks with static settings only will
usually not be included, see conf above.
- - chk off chk off ok Checksum off
If issued twice in succession, this
command will disable checksums.
Note: Responses will still have the
checksums appended.
NOTE1: ? command turns the checksum
back on
- - locate on
locate off locate on 3
locate off ok Card locator
This command will cause all the LEDs to
flash for a user specified number of
seconds. If omitted, the value
will be set to a default of 120 seconds.
The flashing can be terminated at any
time with locate off.
- - address address address Card address
This command will check and update the
card's current rack and slot address,
which is normally only done at start-up.
- - filename filename frshdpgm-0-
105.ffw
filename frshdpgm-0-
100.mfw '.' Firmware upgrades
The part must match the card's
hardware and include a revision number,
and the extension must be either 'ffw' for
FPGA firmware or 'mfw' for
microcontroller firmware. After running
this command the board will wait for the
firmware in Intel-hex format.
- - fin fin ok Finalize
Finalize the programming of the
microcontroller. See description of the
uC bootloader (separate document).