Nevion SPG-AVA-DMUX - Manual (Page 13)

SPG-AVA-DMUX Rev. C
nevion.com | 13
3.2 Detailed control in Gyda mode
All functions of the card can be controlled through the Multicon GYDA control system. The
Multicon GYDA has an information page and a configuration page.
3.2.1 Information page
Figure 4: Multicon GYDA information page
The information page shows a dynamic block-diagram of the board and some additional
informative text. The block diagram updates with the board status, showing input signal
selected and signals missing (by red crosses over signal lines
The information text below the dynamic block diagram lists information not easily conveyed
in a graphical manner.
Electrical input and Optical input will indicate either Signal detected or Loss of signal.
Reclocker will indicate either Locked or Loss of lock.
Phase delay denotes the time difference in samples between incoming sync source and
outgoing video signal.
Video in will indicate the currently selected input source.
Input frequency lock will indicate either Soft (master) or Hard (slave). This is a user setting,
see ch 3.2.8.