NCast Telepresenter M4 - Manual (Page 35)

NCast Telepresenter Reference Manual
3.9.12.Configuration
These parameters control scheduler process:
• Google calendar – Enables or disables scheduling using Google Calendar data.
• Google username – The account containing the calendar to be used.
• Google password – Password for the above account
• iCalendar – Enables or disables scheduling using an iCalendar file.
• iCalendar to upload – Use this item to enter the filename of the iCalendar scheduling file which will
be used.
3.9.13.View Buttons
These buttons allows the operator to check on scheduled events:
• View Google – Check on activities scheduled by Google calendar entries.
• View iCalendar – Check on activities scheduled by iCalendar entries.
3.9.14.Activating the Serial Interface
The IP serial interface on a Telepresenter must be enabled to receive the session start/stop commands from
the scheduler process. By default this interface is “Disabled” (See Section 3.7).
To enable the IP serial interface, bring up the web interface, log into the Telepresenter under the “admin” ad-
ministrative account and go to the Configuration/Telnet screen tab.
The fields on this page are set as follows:
Telnet access - Must be “Enabled” for IP access
Password - Set a password to allow Telnet access
IP restriction - Set this to the IP address of this unit
Port number - The given port “7474” is a non-standard port for telnet protocol access
NCast Corporation Revision 2.2
Page 35