NavCom SF-3050 Quick Start - Manual (Page 3)

SF-3050 Quick Start Guide
96-310033-3001, Rev. E 3 of 4
24. Click (refresh) on the Firmware Info window to
display the installed options.
25. Browse to the NavCom\Firmware folder on the PC. The
Firmware folder is copied from the SF-3050 Product
Configuration USB Flash Drive. It contains the most
current firmware. The firmware file extension is *.s19.

Open the Readme.txt file for additional
information.
26. Compare the current NAV Firmware version in the
Firmware folder with the installed version displayed in
the Firmware Info window

In the example above, the NAV firmware in the
receiver is not current and must be upgraded.
27. Perform one of the steps below.
• If the NAV firmware installed in the receiver is the
most current version, go to the Upload Software
Options section.
• If the NAV firmware installed in the receiver is not the
most current version:
• Check the versions of the other firmware.
• Write down all the firmware that must be updated.
• Go to the Upload Firmware section below.
Upload Firmware
Upload a Unified File
28. Select Unified File Loader on the File Upload window:
29. Click and browse to NavCom\Firmware on the PC
and select a unified firmware file to upload.
30. Click . The options to be uploaded are checked
on the Ready to Downline Load File window.
StarUtil 3000 will auto-read the reciever and select files
to load. Check or uncheck firmware files if necessary
(based on existing loaded version numbers).
31. Click and the upload progress window
updates.
32. When the upload is complete, click Close.
33. If any file failed to upload, refer to the section “Upload a
Single Firmware File” in Chapter 3 of the StarUtil 3000
User Guide.

Do not close StarUtil-3000. Continue to the next
section.
Upload StarFire License

For this initial configuration, the StarFire license
must be installed via data cable. Subsequent
renewals of the license are typically transmitted to
the receiver via radio broadcast. Refer to the SF-
3050 User Guide.

The receiver must be tracking GPS satellites and
providing a valid position solution at the time of
the StarFire license upload to accept the license.
NAV Firmware
Firmware Info Window
Click the
Refresh
Button
NAV Firmware
Firmware in Receiver Current NAV Firmware
Click the
Refresh
Button