MultiDyne SilverBack II - Manual (Page 8)

AUDIO
This section describes the details specific to SilverBack II audio.
There are two balanced MIC preamp channels available for microphones or other sources
that are associated with the camera.
Each MIC preamp channel features adjustable gain from 0 to 60 d
addition, each MIC input has selectable 48V phantom power.
MIC 1 and 2 + - buttons on the front panel are used to make adjustments to the gain. LED
indicators will display the main microphone VU level or gain selection when gain modified. To
turn the Phantom Voltage ON or OFF for a particular input, press and hold the desired PH
button for approximately 1 sec.
Refer
APPENDIX A for Pin-Out details.
Figure
-5-
This section describes the details specific to SilverBack II audio.
There are two balanced MIC preamp channels available for microphones or other sources
that are associated with the camera.
Each MIC preamp channel features adjustable gain from 0 to 60 dB in 10 dB increments
addition, each MIC input has selectable 48V phantom power.
buttons on the front panel are used to make adjustments to the gain. LED
n microphone VU level or gain selection when gain modified. To
turn the Phantom Voltage ON or OFF for a particular input, press and hold the desired PH
Out details.
Figure 4 - MIC/Audio Inputs and Controls
There are two balanced MIC preamp channels available for microphones or other sources
B in 10 dB increments. In
buttons on the front panel are used to make adjustments to the gain. LED
n microphone VU level or gain selection when gain modified. To
turn the Phantom Voltage ON or OFF for a particular input, press and hold the desired PH