MultiDyne SilverBack II - Manual (Page 12)

-9-
RETURN VIDEO
You can use this input to provide an SDI video signal back to the camera unit. Primarily, you
can use this with a viewfinder, prompter, and so on. The return video supports all SMPTE
video rates up to 3GBps as well as embedded audio.
REFERENCE
You can use the reference input to provide a reference signal to the camera for genlocking
purposes. SilverBack II supports Black Burst and Tri-Level sync signals. A Loop-Through
output is provided for connecting to additional equipment.
Note: It is highly recommended that you use Tri-Level sync for HD video and Black Burst for
SD video.
AUDIO
This section describes MIC/Line audio 1 and 2 outputs.
These XLR connectors provide the analog outputs from the corresponding inputs at the
camera unit. MIC/Line selection, as well as audio gain is set at the camera unit. You can set
the full scale (FS) output level from 0 dBu to a maximum of +24 dBu.
Refer
APPENDIX A for Pin-Out details.
Figure 11 - Reference Input
Figure 12 - MIC/Line Audio 1 and 2 Outputs