DirecTV DTV-MD0-0058 - Manual (Page 26)

DIRECTV Set-top box information for the installer
DIRECTV Proprietary November 17, 2005
Version 1.1.a Page 26 of 49 DTV-MD-0058
0xD4 Exit (key #30) 0xEC Green (key #41)
0xD5 Power (key #7) 0xED Blue (key #42)
0xD6 Previous Channel (key #21) 0xF7 Menu (key #28)
0xF8 Format (key #51)
Note: All keys not otherwise identified above will be considered RESERVED.
Return Data Stream None
Return Response ACK_FCNOK : Success
NACK_FCNOK : Failure – Undefined command
Return Value 0x0000 : Success
0x0001 : Failure – Command not supported for specified device
Others : Failure – Bad command
Description The STB will execute a SendUserCommand command by sending the defined user
command to the user interface task.
This operation can take place whether command DisableUserEntry (0x13) is active or
not. The STB will respond to the user command as though a user button on the keypad
or remote control were pressed. Most commands require both a down and an up key
press.
The type Key Toggle will take 60 ms.
Note: There is a chance for command conflict if DisableUserEntry is not active,
particularly from stray IR remote control signals.
Example #1:
Scenario – Change to channel 278.
Input SendUserCommand 0xFA 0xA5 0x00 0x01 0xE2 0xFA 0xA5 0x00 0x01 0xE7 0xFA
0xA5 0x00 0x01 0xE8
Each digit in 278 is input separately. Below is the input for the first digit “2”.
Input 0xFA 0xA5 0x00 0x01 0xE2
Description Command
Initializer
Command
ID Key toggle Remote Digit 2
Return Data – 0xF0 0xF2 0xF4
Output 0xF0 0xF2 0xF4
Description Successful command acknowledgements