DirecTV DTV-MD0-0058 - Manual (Page 24)

DIRECTV Set-top box information for the installer
DIRECTV Proprietary November 17, 2005
Version 1.1.a Page 24 of 49 DTV-MD-0058
5.10 DisableUserEntry (0x94)
Command Label DisableUserEntry
Command Byte 0x94
Input Parameter(s) None
Return Data Stream None
Return Response ACK_FCNOK : Always Success
Return Value 0x0000 : Always Success
Description The STB executes a DisableUserEntry command by blocking remote control and front
panel key presses from reaching the user interface handler. Instead user commands
(front panel entries and IR remote control entries) may be obtained using the
GetUserCommand service command.
5.11 GetReturnValue (0x95)
Command Label GetReturnValue
Command Byte 0x95
Input Parameter(s) None
Return Data Stream [RVal3][RVal2][RVal1][RVal0]
Return Response ACK_FCNOK : Always Success
Return Value None : Preserves the previous return value
Description The STB will execute a GetReturnValue command by returning the Return Value
from the last issued Command that generated a return value.
5.12 Reboot (0x96)
Command Label Reboot
Command Byte 0x96
Input Parameter(s) None
Return Data Stream None
Return Response None 2
Return Value None
Description The STB will execute a Reboot command by performing a hard reset of the STB.
This command has the same effect as pressing the red reset button on the STB.
2
Since a hard-reset is performed, no return value or return response can be provided.