Monster HTUPS 2700 User Manual
Page 24
17
TROUbleSHOOTInG
COn’T
Symptom
Possible Cause
Remedy
HTUPS 2700 is not
providing power .
HTUPS 2700 is not
turned on .
• Make sure HTUPS 2700’s AC power plug is plugged into
a properly grounded 120V wall outlet . Unit should turn
on right away .
• In some situations, a wall switch may need to be turned on
to send electricity to the wall outlet . Try turning on the light
switches located near the wall outlet powering HTUPS 2700 .
Battery voltage is low .
• Verify that the internal battery connection is secure.
(See Instructions on page 11)
• Recharge HTUPS 2700’s battery for at least 4 hours.
(Contact your Monster Power dealer if battery does not charge .)
HTUPS 2700
is defective .
• Please see warranty information.
Too many devices are
connected, causing an
overload, tripping the
Thermal Circuit Breaker .
• Press the HTUPS Thermal Circuit Breaker button in to reset.
Please allow 10 minutes before attempting to reset . If you reset
too soon, the breaker will prematurely sense power overload
and not allow the PowerCenter to operate .