Monster HTUPS 2700 User Manual
Page 17

10
baTTeRY COnneCTIOn anD RePlaCeMenT InSTRUCTIOnS
For safety reasons, the HTUPS 2700 is shipped with the internal battery disconnected . The HTUPS 2700 will not operate
until the internal battery is first connected . Follow these steps to connect or disconnect the battery .
Step One:
Use a Phillips head screwdriver to remove
the screws on the bottom of the HTUPS, and open
the cover of the battery compartment .
Step Two:
Connect the battery to the internal
wire of the HTUPS .
IMPORTanT: Before using the HTUPS 2700 for the first time, charge the battery for at least 4 hours to reach full charge
capacity . Failure to do so may limit the runtime of the battery .