MK Products CobraCooler 1999 - Manual (Page 13)

Owner’s Manual - Page 13
inert gas hose and water hose assembly with quick-disconnect connectors.
This extension cable is to mate any of the MK orbital 500X series weldheads
to the CobraCooler™.
7.2 Water Hose Assembly
The second is a 25 ft. water hose assembly, P/N 005-0636. It consists of two
25 ft. hoses with two male quick-disconnect connectors on one end and two
male double-end shutoff connectors on the other end. This water hose
assembly is to mate any of the MK orbital 600X series weldheads to the
CobraCooler™.
Section 8 SPARE PARTS
8.1 Fuse
WARNING
DISCONNECT UNIT FROM ALL POWER SOURCES PRIOR TO CHANGING
FUSE.
ELECTRIC SHOCK CAN KILL
Located on the front panel of the CobraCooler™ is a 0.50 amp BUSS fuse. If
the unit does not turn on with the power switch, check the integrity of the fuse.
Turn the fuse cap on the front panel and remove fuse. Check fuse using
continuity meter. Replace if necessary.
8.2 Coolant Flow Filter
Periodically, the mesh-screen filter may require cleaning and/or replacement.
It is recommended that all coolant be removed from the CobraCooler™ prior
to changing filter. In order to drain the coolant, locate and remove the drain
plug on the bottom of the cooler. The filter can now be removed from the
reservoir and cleaned or replaced.