MK Products Cobra MX - Manual (Page 9)

Cobra ® MX Euro Compatible™ 7 Pin Owner's Manual - Page 2
Coolant Connections
If so equipped, the ends of the coolant hose push
over a barbed fitting on
the end of the gun body and are secured by twisting the hose retainer to the
end of the hose. The hose retainer is re-usable and can be removed and
re-installed as needed.
The BLUE coolant supply hose pushes over a
barbed fitting on the end of
the gun body and is secured by twisting the hose retainer to the end of the
hose. The hose retainer is re-usable and can be removed and re-installed as
needed.The opposite end of the BLUE hose pushes into a threaded coolant
fitting.
The RED coolant return hose pushes over the
barbed fitting in the Power
Manifold. The opposite end of the RED hose pushes into a threaded return
hose of the coolant recirculator.
Both the BLUE and RED threaded fittings on the end of the BLUE and RED
hoses, are standard left-hand thread. MK Products compatible guns have
interchangeable fittings, so you can match as needed for your cooler. Both
types of fittings require a hose retainer.
Control Cable
A multi-conductor control cable is used on the Cobra MX Euro Compatible 7
Pin. The gun end of the cable is secured with a cable clamp and the wires
are connected to the potentiometer, the micro switch, the motor and the gun
body mechanically. Slack is left in the electric cable as it exits the back of the
gun to prevent cable and/or wire breakage. The cabinet end has a seven pin
"W" clocked amphenol connector.
Section B operation
General
The Cobra MX Euro Compatible 7 Pin gun maintains a constant, steady,
uniform wire feed speed, regardless of curved or looped wire conduit. The
constant push exerted by the slave motor in the cabinet, combined with the
pull of the gun motor, causes the wire to literally float friction-free through
the wire conduit. The 24VDC gun motor is controlled by a three and three-
quarter (3 3/4) turn potentiometer in the gun handle.
Controls and Settings
Potentiometer
The laterally-positioned potentiometer is located in
the lower end of the handle, providing up to 800 ipm
with 3 3/4 turns.
Micro Switch
The micro switch assembly consists of the micro
switch, and leads.
Trigger Sensitivity
The amount of trigger lever travel can be shortened
for a quicker or more responsive action.
A more sensitive trigger lever is produced by
reducing the gap between the trigger lever and the
micro switch lever. By turning-in the trigger sensitivity
adjustment screw, it closed the gap between the
Trigger Sensitivity Adjustment
Screw Location
Screw adjusted out of trigger,
pre-setting the micro-switch
lever for shorter motion
sensitivity.
431-1898
5/16” Hose Retainer
431-1910
Quick Connect Fitting
431-1893*
Nipple
753-3379*
Left-Hand Threaded Fitting
*Must be ordered together