Mini Tec MTB2 Kit - Manual (Page 9)

9
need our MK1/2 Subframe Mounting Kit. Standard Mini mounting bolts are circled
in red in the following photo. Do not tighten completely at this point. You will need
to attach the frame and the bottom first.
Step 2: Drill six holes to support the bottom of the frame using a 5/16” drill
bit. Use the six supplied 5/16” bolts with plates to fasten the frame to the car on the
lower side. The plates will go inside of the car to give the floor panel extra support.
After the six bolts are in place and tightened, tighten the two large frame mounting
bolts on top of the frame. See photos.