Mini Tec MTB2 Kit - Manual (Page 14)

14
Axle Installation:
Simply slide one of the axles into the transmission and the
other into the engine mid-shaft until the axles lock into place.
Swivel Hubs and Brakes:
Install the Swivel Hubs and Brakes as done on stock Mini.
Master Cylinder:
Depending on your setup, you may have to relocate one of your master cylinders. If
you have both master cylinders on the right side of the car, then they are clear. If you
have both master cylinders on the left side, then the brake master cylinder will have
to be relocated. We recommend getting a left hand drive conversion pedal box. This
will allow you to mount the master cylinder on the right side of the car, clear of any
objects. Note: For best clearance, check out Mini Tec’s Aluminum Racing Pedal Kit.
Shifter Linkage:
Use Honda Shifter linkage for the conversion.
Step 1: Cut all four ends off of the shifter linkage.
Step 2: Hang shifter in stock Mini location. New holes will need to be drilled. (See
following Photo)