Microsens MS400941 - Manual (Page 7)

5
4. Plug in the power cable of the Power over Ethernet Splitter to the PD’s
power plug.
5. Adjust the Voltage for PD; switch the DIP setting on the Power over
Ethernet Splitter. It supports four sorts of voltage output–5V, 7.5V, 9V
and 12V. The default value will be set on 5V. When you change
voltage by DIP, the Power over Ethernet Splitter must be in powered
off status.
6. Before starting, make sure all connections are correct and the output
voltage is set in the right position.
 The Power over Ethernet Splitter connects to the Switch or PoE
Hub via Data in port.
 The Power over Ethernet Splitter connect to the PD has two
connections – Data out and Power out.
 The voltage has four options–5V, 7.5V, 9V and 12V.