Microsens MS400941 - Manual (Page 6)

4
 DIP switch: It is used for switching the voltage which supplies to PD.
It provides four voltage output options–5V, 7.5V, 9V and 12V. When
you adjust the DIP switch, please power off the Power over Ethernet
Splitter.
DIP Switch
Package Contents
 One Power over Ethernet Splitter
 2 DC Power Jack—5.5 x 2.0mm and 5.5 x 2.5mm
 User Manual
Compare the contents of your Power over Ethernet Splitter package with
the standard checklist above. IF any item is missing or damaged, please
contact your local dealer for service.
Installation
To install the Power over Ethernet Splitter, please follow the steps as
follows.
1. Connect the side of RJ-45 cable to DATA IN port on the Power over
Ethernet Splitter, and connect another side with the PoE Switch/HUB
(which is Data out equipment). If the Switch/HUB does not support
PoE function, you need to install a PoE injector between Switch/HUB
and Power over Ethernet Splitter.
2. Use RJ-45 cable that is on the Data out port in Power over Ethernet
Splitter to connect with the PD (Such as Router, Access Point…etc.)
3. Choose the power cable (Internal Diameter 2.0mm or 2.5mm) and plug
into the Power out port on the Power over Ethernet Splitter.