beautypg.com

Nstallation, Installation – Microsens MS400920 User Manual

Page 7

background image

5

Compare the contents of your Power over Ethernet Injector package with

the standard checklist above. IF any item is missing or damaged, please

contact your local dealer for service.

Installation

To install the Power over Ethernet Injector, please follow the steps below.

1. Use RJ-45 cable to connect the Data in port of the Power over

Ethernet Injector to Switch/HUB.

2. Use RJ-45 cable to connect the Data out port of the Power over

Ethernet Injector to PoE Splitter, PD (Such as Router, Access

Point

…etc.) or PoE Hub.

3. Plug in the power cord of the Power over Ethernet Injector to the wall

power plug.

4. Before starting, make sure all connections are correct.

 The Power over Ethernet Injector connects to the Splitter, POE

Hub or PD via Data Out port.

 The Power over Ethernet Injector connects to the switch/hub via

Data In port.

 The Power In port is to get the power supply for Power over

Ethernet Injector from wall power plug.