Microsens MS655020X - Manual (Page 9)

Ethernet VDSL2 Extender - manual Page 9/9
MICROSENS GmbH & Co. KG - Kueferstraße 16 - 59067 Hamm / Germany - Tel. +49 23 81/94 52-0 - FAX -100 - www.microsens.com
Troubles shooting
Check the configuration DIP-switch. It must be setting in the same operation
mode with the link partner.
Select the proper Copper/Phone-line cable to construct your network. Please
check that you are using the right cable.
Warnings
FCC Warning
This Equipment has been tested and found to comply with the limits for a Class-A
digital device. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and
can radiate radio frequency energy. It may cause harmful interference to radio
communications if the equipment is not installed and used in accordance with the
instructions. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the
following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
CE Mark Warning
This is a Class-A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
MICROSENS reserves the right to make any changes without further notice to any product to improve reliability, function or design.
MICROSENS does not assume any liability arising out of the application or use of any product. 4909/pp