Microsens MS655104 - Manual (Page 20)

16
2.4 Network Connection
The 4 10/100TX + 2 or 1 100FX Industrial Switch has the SC type fiber port using in
multi mode (2Km) or single mode (30Km). When you connect the fiber port to another
one, please follow the below figure to connect it. Wrong connection will not allow the
port to work normally.
Figure 2.8: Pin Assignment of the Power Connector
Attention This is a Class 1 Laser/LED product. Don ’t stare into the Laser/LED Beam.
The 4 10/100TX + 2 and 1 100FX Industrial Switch both have 4 x RJ-45 ports that
support connection to 10 Mbps Ethernet, or 100 Mbps Fast Ethernet, and half or full
duplex operation. 4 10/100TX + 2 or 1 100FX Industrial Switch can be connected to
other hubs or switches through a twisted-pair straight through the cable or a crossover
cable up to 100m long. The connection can be made from any TX port of the 4
10/100TX + 2 or 1 100FX Industrial Switch (MDI-X) to another hub or switch either
MDI-X or uplink MDI port.
The 4 10/100TX + 2 or 1 100FX Industrial Switch supports auto-crossover to make
networking more easy and flexible. You can connect any RJ-45 (MDI-X) station port on
the switch to any device such as a switch, bridge or router.