Metz MECABLITZ 64 AF-1 digital Pentax - Manual (Page 187)

10.2 Remote controller mode settings
In remote control mode the flash of the
master flash unit only assumes the control
function and does not contribute to exposure
of the shot!
10.2.1 Remote master mode settings
• Switch on the flash unit with the ባ
button.
The start screen appears.
• Press the sensor button of the displayed
mode of operation on the touch display as
many times as it takes for the display for
selecting the mode of operation to appear.
• Press the sensor buttons on the
touch display and select .
• Press the sensor button on
the touch display.
Remote master mode is set.
REMOTE CONTROL
REMOTE CONTROL
10.3 Remote slave flash mode
The flash unit supports the wireless Pentax P
TTL remote system.
At the same time, one or more slave flash
units can be remotely controlled from one
master flash unit on the camera (e.g. meca-
blitz 5 64AF-1P digital).
So that multiple remote systems in the same
room do not interfere with one another, there
are four independent remote channels avai-
lable (CH 1, 2, 3 or 4).
Master and slave flash units belonging to the
same remote system must be set to the same
remote channel.
The slave flash units must be able to receive
the light from the master flash unit with the
integrated sensors for the remote mode .
Depending on the camera model, the came-
ra’s internal flash unit can also function as
master flash unit.
187
k
MODE
O
q p
REMOTE MASTER
REMOTE CONTROL
REMOTE SLAVE
0.8- 9.0 m
F
5,6
M-
Zoom 35 m
m
PTTL
i
EV
M-
Zoom 35
i
m
m
REMOTE
CONTROL