Metz MECABLITZ 64 AF-1 digital Pentax - Manual (Page 183)

Mecabounce (accessory) is mounted.
If so desired, the position of the reflector can
be manually adjusted in order to achieve par-
ticular lighting effects (such as spot effect
etc.).
Manual zoom mode
The zoom position of the reflector must be
adjusted manually to the lens focal length
when used with a camera that doesnít trans-
mit the data related to the lens focal length.
In this case auto-zoom mode is not possible!
After switching on the flash unit, „Zoom“
appears in the display and the current zoom
position of the reflector appears.
Setting procedure
• Press the ቨ button as often as it takes
for the selection menu to appear.
• Press the sensor button on the
touch display.
• Press the sensor buttons on the
touch display and select .
• Press the sensor button on the
touch display.
• Press the sensor buttons on the
touch display and select the desired zoom
value.
• Press the sensor button on the touch
display for the desired zoom value
The setting will take effect immediately.
The following zoom positions are possible for
the reflector: 24 - 28 - 35 - 50 - 70 - 85 - 105-
135-180-200 mm (35 mm format).
Tip:
If you do not necessarily need the full guide
number and maximum flash range of the
flash unit, you can leave the zoom reflector at
the position for the shortest focal length of
the zoom lens.
This will provide full light coverage of the pic-
ture and eliminate the need to continually
adjust it to the focal length of the lens.
PARAMETER
D
ZOOM
ZOOM
183
PARAMETER
PARAMETER
O
q p
P/EV
ZOOM
F
ZOOM
O
q p
70
85
105
+
k