Metz MECABLITZ 64 AF-1 digital Sony - Manual (Page 188)

10.2.5 Setting partial light output/exposure
correction
• Press the sensor button on the touch
display for the partial light output/exposu-
re correction (e.g
/ ) . The window
for the selection appears.
• Press the sensor button on the touch
display for the desired mode of operation
or .
• Press sensor buttons on the
touch display and set the desired partial
light output to 1/1, 1/2, 1/8 or 1/256.
The partial light output is adopted.
Once the slave flash units have achieved
flash-readiness, the AF measurement flash
flashes.
EV 1/1
EV P
10.3 Testing remote flash mode
• Place the slave flash units in the desired
positions for the shot.
Use flash unit mounting foot S60 to set up
the slave flash unit.
• Wait for all of the flash units involved to
become flash ready. Once the slave flash
units are flash ready, the AF auxiliary ligh
ተ will blink.
• Press the manual firing button ቨ on the
master flash unit to fire a test flash.
The slave flash units will respond in succes-
sion, according to slave group, with a test
flash. If a slave unit fails to fire a test flash,
check the settings for remote channel and
slave group. Correct the position of the sla-
ve flash unit so that it is able to receive
light from the master flash unit via the sen-
sor
ብ.
The flash mode is transmitted automatically
by master.
When the flash unit functions as master in
the cordless remote system, the activation of
the modelling light also activates the model-
ling light of slave flash units.
188
k
M-
Zoom 24
REMOTE
SLAVE
RMT Ch
2 2
i
m
m
P
1/1
SLAVE
O
TTL
M
EV / P
P
O
q p
1/4 - 2/3
1/8
1/8 - 1/3