Metz MECABLITZ 64 AF-1 digital Sony - Manual (Page 177)

177
Setting number of flashes (N)
• Press the sensor button for the number of
flashes on the touch display.
• Press the sensor buttons on the
touch display and select the desired num-
ber of flashes.
The maximum possible number of flashes
(N) depends on the set partial light output
(P).
• Press the sensor button on the touch
display for the desired number of flashes
(in the example
.
The setting will take effect immediately.
4
N
Setting the flash frequency (f(Hz))
• Press the sensor button on the touch
display for the flash frequency .
• Press the sensor buttons on the
touch display and select the desired fre-
quency of flashes.
The maximum possible frequency of flashes
(f) depends on the set partial light output
(P).
• Press the sensor button on the touch
display for the desired frequency of flashes
in the example
.
The setting will take effect immediately.
The valid distance to the set parameters is
shown on the display. The distance value dis-
played can be adjusted to the distance from
the subject by changing the f-stop or the par-
tial light output.
The aperture and ISO values are not shown
on the display in Strobe flash mode!
The secondary reflector is not supported in
the Stroboscopic flash mode.
f (Hz)
8
f (Hz)
O
q p
7
8
9
3.1m
M-
Zoom 35 m
m
STROBO
i
P
1/16
f(Hz) 10 N 4
3.1m
M-
Zoom 35 m
m
STROBO
i
P
1/8
f(Hz) 8 N 4
k
+
+
+
3.1m
M-
Zoom 35 m
m
STROBO
i
P
1/16
f(Hz) 10 N 5
N
O
q p
3
4
5