Metz MECABLITZ 52 AF-1 digital Nikon - Manual (Page 148)

148
k
STANDBY
Off
41 min
10 min
• the camera’s exposure metering system is
switched off. . .
. . . switched to stand-by mode, (Auto-OFF) to
save energy and to protect the power source
from unintentional discharging. The active
automatic unit switch-off is shown in the
INFO display.
The flash ready indicator
ቧ and the indica-
tors on the LC display disappear.
The
ቨ button flashes red in stand-by
mode.
The most recently used operating setting is
retained after automatic shutdown and is
immediately restored when the camera is
switched on.
The flash unit can be turned on again by
pressing the
ቨ button, or by tapping on
the shutter release (wake-up function).
In slave-/ servo mode, the automatic cut-off
is not activated.
The flash unit should always be turned off
using the main switch
ባ if it is not going
to be used for an extended period.
If necessary, the Auto OFF function can be set
to occur after 1 minute of inactivity, or can be
deactivated.
The flash unit switches off completely about
1 hour after its last use.
D
D
Setting the automatic unit switch-off
• Switch on the flash unit with the
ባ but-
ton. The start screen appears. The flash
unit always switches on afterwards with the
mode of operation that was used last (e.g.
manual flash mode M).
• Press the
ቨ button as often as it takes
for the selection menu to appear.
• Press the sensor button on the
touch display.
• Press the sensor buttons on the
touch display and select „STANDBY”.
• Press the sensor button on the
touch display.
• Tap the sensor button on the touch display
for the desired time. The setting is adopted
immediately. The operation display appe-
ars after about 10 seconds, or press the
ቨ button repeatedly until the operation
display appears.
The
ቨ button flashes red in stand-by
mode.
D
OPTION
STANDBY
D
D
+
ZOOM MODE
STANDBY
MOD.LIGHT