Metro Stop Kit for Baskets and Totes - Manual

Part No. INST-SXBTSTOP
Date: 10/09/01
1. On the hinge side of the unit, locate the flat post filler in the post. Using a sharp knife, make a vertical cut in
the filler strips above, between and below the hinges. Remove the filler strip sections.
2. Cut the new stop extrusion into sections to fit above, below and between the hinges. Make sure the flat or
wing on the extrusion is facing toward the rear of the unit.
3. On 90
?
hinge doors, hinge stop plates must be installed. Loosen the hinge mounting screws and slide the
plate under the screw heads. Tighten screws after plate is in place. Repeat for other hinge. For 270
?
hinge
doors stops are not required. The edge of the hinge acts as the stop. All tall doors require 2 stop kits
INSTALLATION
INSTRUCTIONS
Stop Kit for Baskets and Totes
This Kit contains: (1) 36-1/2 stop extrusion on and (2) 90
?
hinge stop plates