Dimplex V1525RT - Manual (Page 6)

4
NOTE: Procedures and techniques that are
considered important enough to emphasize.
CAUTION: Procedures and techniques, which, if not
carefully followed, will result in damage to the
equipment.
WARNING: Procedures and techniques, which, if not
carefully followed, will expose the user to the risk of
fire, serious injury, illness or death.
Step-by-Step Installation
NOTE
A 15amp, 120-volt circuit is required. A dedicated
circuit is preferred but not essential in all cases. A
dedicated circuit will be required if, after installation, the
circuit breaker trips or the fuse blows on a regular
basis when the heater is operating. Additional
appliances on the same circuit may exceed the current
rating of the circuit breaker.
WARNING
Ensure the power cord is not installed so that it is
pinched or against a sharp edge and ensure that the
power cord is stored or secured to avoid tripping or
snagging to reduce the risk of fire, electric shock or
injury to persons.
Construction and electrical outlet wiring must comply
with local building codes and other applicable
regulations to reduce the risk of fire, electric shock and
injury to persons.
Do not attempt to wire your own new outlets or circuits.
To reduce the risk of fire, electric shock or injury to
persons, always use a licensed electrician.
WARNING
The In-Stud fireplace is wall mountable and can be
build-in the wall space 16" over-center between 2"x4"
wall studs. Follow the installation instructions for either
wall mount or built-in mounting; failure to do so may
cause damage or injury.