Dimplex V1525RT User Manual
Page 18
Helpful Hints
It is a good idea to replace all light bulbs at one time if
they are close to the end of their rated life. Group
replacement will reduce the number of times you need
to open the unit to replace light bulbs.
Light Bulb Requirements
Quantity of two 40W Chandelier or candelabra bulbs
with E-12 (small) socket base, 120 Volt.
DO NOT EXCEED 40 WATTS PER BULB
Bulb Replacement Instructions:
1. Disconnect power supply to the fireplace either by
unplugging the fireplace or switch off at the breaker
panel.
2. Remove fireplace front trim.
3. Remove glass assembly. Remove the screws
securing the glass assembly on the chassis. Hold
on to the handles on the glass assembly with both
hands then lift the whole assembly straight up to
remove. Figure 10.
4. Remove the two screws securing the light block as
shown in Figure 11, then remove the light block.
5. Reach in and turn the burnt-out bulb(s) counter-
clockwise to remove.
6. Replace with new bulbs.
7. Reassemble light block, glass assembly and
fireplace frame in reverse order.
Handle
LIFT TO
REMOVE
Handle
Figure 10
16
Glass Assembly