Metro Case Carts - Manual (Page 2)

Case Carts
To Remove Shelves:
Push shelf to rear of cart. Lift the rear of the
shelf until the shelf rollers/wire loops are free
of the shelf slide notches. And then remove
shelf from cart.
To Change Shelf Levels:
Remove shelf from cart. Grasp a shelf slide
front and lift up until free of key slot in side
of cart. Pull slide forward until shelf slide
rivet is free of keyhole slot. Re-position at
desired level, locking shelf slide into slots.
Repeat on other side. Reinstall shelf.
2. Lay the shelf on the shelf slides making
sure the two wire loops or rollers are toward
the rear and on the bottom. Slide shelf back
until loops or rollers fall into shelf slide notches.
Pull shelf forward making sure wire loops/rollers
are undershelf slides (Fig. 9, Fig. 10). 3. The shelf can be pulled out for easier
accessibility of contents. Stops are built into the
shelf slides to prevent shelf from being pulled
out too far (Fig 11).
CASE CART CLEANING/STERILIZATION GUIDE FOR MANUAL CLEANING
YES ratings are based on adherence to the manufacturer’s
recommended dilution ratio for the cleaner/disinfectant
concentrate being used (where applicable), at ambient
temperatures not exceeding 72° F (22.2° C), and with
intermittent exposure times not exceeding15 minutes
each exposure.
To Install Wire Pullout Shelves or
Roller Shelves:
Fig. 9
Fig. 10
Fig. 11