Measurement Computing CIO-CTR05 - Manual (Page 14)

14
Chapter 3
Specifications
All specifications are subject to change without notice.
Typical for 25 °C unless otherwise specified.
Specifications in italic text are guaranteed by design.
Counter
Refer to the CTS9513-2 data sheet for complete 9513 specifications and operating modes. The data sheet is
available on our web site at www.mccdaq.com/PDFmanuals/9513A.pdf .
Table 1. Counter specifications
Parameter Conditions
Counter type 9513
Configuration One 9513 device. Five up/down counters, 16-bits each.
Clock input frequency 7 MHz max
X2 clock input source 1 MHz (10 MHz Xtal divided by 10)
High pulse width (clock input) 70 ns min
Cycle time (clock input) 145 ns min
Gate pulse duration 145 ns min
Input low voltage –0.5 V min, 0.8 V max
Input high voltage 2.2 V min, 5 V max
Output low voltage 0.4 V max @ 3.2 mA
Output high voltage 2.4 V min @ –200 µA
Crystal oscillator frequency 10 MHz
Frequency accuracy 100 ppm
Interrupts
Table 2. Interrupt specifications
Number of interrupts 2 to 7, jumper selectable
Interrupt enable External, enabled with TTL low level
Interrupt sources External
Digital input / output
Table 3. Digital I/O specifications
Digital type Output: 74ACT273
Input:
74LS373
Configuration 1 bank of 8 as output, 1 bank of 8 as strobed input
Number of I/O 8 input, 8 output
Output high 2.7 volts min @ –0.4 mA
Output low 0.5 volts max @ 8 mA
Input high 2.0 volts min, 7 volts absolute max
Input low 0.8 volts max, –0.5 volts absolute min