Datavideo MP-6000 Mk2 - Manual (Page 38)

37
To access other options press the Down Arrow button to select
Contrast, Color and Tint (NTSC only)
The procedure for setting Contrast, Color and Tint (NTSC only) is the same as for Brightness.
Once all the adjustments are correct, press the Menu button to
exit the Color Correction menu and return to the General
Display
These color correction settings will be stored as your default settings for the unit.
If you wish to return to the factory default at any point, follow the above procedure but highlight DEFAULT
and press the Enter button, then highlight SAVE and press the Enter button again.
Audio Level Adjustment
This setting applies to analogue inputs only; it is not available from a DV (Digital) source.
It is important to make sure that the audio level from your input source is not too high, as this will cause
distortion on the finished disc. The MP 6000 has a built in audio level control that allows you to optimize the
audio level prior to recording.
The LED’s above the adjustment knob will light up to show the volume of the incoming audio. It is ideal to
adjust the knob so that the red LED occasionally lights up, when then is a particularly loud noise, but it is
not illuminated at any other time.