Quick start guide – Datavideo MP-6000 Mk2 User Manual

Page 16

Quick Start Guide:

As the heading suggests, this is the quick start section. If you require more detailed operating

instructions please go to page 18.

Step 1: Turn on power to the MP-6000, the source and the monitor.

Step 2: Press the “POWER” button, to turn on the MP-6000. The word “MP-6000” and then “BOOT”

will appear on the display window. After a couple seconds, it will present “NO Disc” that means

the tray is empty. Please place a disc on the tray.

Note: The upper right window on the TV screen will show two lines of data. One is the

status of the unit, the other one is the input format setting.

Step 3: Press the “EJECT” button once, the tray will come out, the word “OPEN” appears in the

window. Please put the DVD+R or RW disc with the printing surface up, and then press the

“EJECT” button again. The tray will return into the MP-6000.

Step 4: The word ' Reading ' appears on the screen, in the upper right corner, this means the MP

6000 is reading the disc. If the disc contains previous recordings, it will be detected during the

read process. If there is a recording present you can press the “PLAY“ key and play out the

program immediately.

Step 5: If it is a blank/brand-new disc, the MP-6000 will start the formatting process immediately. A

window will appear saying “FORMATTING.” The entire process will take approximately 20 second.

Note: It’s necessary to format the disc before you start recording.

Step 6: Press the “INPUT“ button to choose the input signal source.

Step 7: Press the “QUALITY” button on the panel to choose HQ / SP / LP / EP / SLP record quality.

Once this is set you can start recording.

Step 8: Before you start to record, you can adjust video input source quality by using the color

processor of the MP-6000.

a. Press the “MENU” button once, choose '”1.COLOR CORRECTION”, then press the “ENTER”

button. Use the Up and Down arrow buttons to move to different categories.

z Brightness

Contrast