Measurement Computing GPIB-488 - Manual (Page 14)

GPIB-488 3-1 Programming Reference Manual
3
GPIB 488.1 Library Reference
This chapter describes each of the 488.1 GPIB library routines. A short
description of the routine, its syntax, parameters, any values that are
returned, any special usage notes, and an example are included for each
routine. The routines are listed in alphabetical order. The following table
lists all of the 488.1 GPIB library routines. A full description of each
routine follows the table.
Table 3-1. 488.1 Library routines
Name Description
ibask Returns software configuration information
ibcac Become Active Controller
ibclr Clear specified device
ibcmd Send GPIB commands from a string
ibcmda Send GPIB commands asynchronously from a string
ibconfig Configure the driver
ibdev Open and initialize a device when the device name is unknown
ibdma Enable/Disable DMA
ibeos Change EOS
ibeot Change EOI
ibfind Open a device and return its unit descriptor
ibgts Go from Active Controller to standby
ibist Define IST bit
iblines Return status of GPIB bus lines
ibln Check for presence of device on bus
ibloc Go to Local
ibonl Place device online/offline