Measurement Computing USB-1408FS - Manual (Page 8)

USB-1408FS User's Guide Installing the USB-1408FS
8
If the LED turns off
If communication is lost between the device and the computer, the device LED turns off. Disconnect the USB
cable from the computer and then reconnect it. This should restore communication, and the LED should turn on.
Allow the USB-1408FS to operate for at least 30 minutes before using the device. This warm up time is
required to achieve the specified rated accuracy of measurements.
Calibrating the USB-1408FS
The USB-1408FS is shipped fully calibrated. Calibration coefficients are stored in EEPROM. Return the device
to Measurement Computing Corporation when calibration is required. The normal calibration interval is once
per year.