Measurement Computing PCI-DIO96 - Manual (Page 19)

PCI-DIO96 User's Guide Specifications
19
Interrupts
The interrupt control registers allow the four 82C55 devices and the 8254 counter timer to be used as interrupt
sources.
Table 4. Interrupt specifications
Interrupt INTA# - mapped to IRQn via PCI BIOS at boot-time
PCI Interrupt enable Programmable through PLX9052 INTCSR register (INTCSR 4Ch)
Interrupt polarity High or low level. Programmable through PLX9052
Rising or falling edge. Programmable through PLX9052
Interrupt sources 82C55 in Mode 1 or Mode 2 interrupt configuration:
 First Port C0
 First Port C3
 Second Port C0
 Second Port C3
 Third Port C0
 Third Port C3
 Fourth Port C0
 Fourth Port C3
Note: Any interrupt source above may be individually enabled.
82C54 Counter
 Counter 1 OUT
 Counter 2 OUT
Note: Counter 1 and 2 interrupts are exclusive. Only one counter may be
enabled as an interrupt source at one time.
Crystal oscillator
Table 5. Crystal oscillator specifications
Oscillator type AT-cut crystal
Frequency 16 MHz
Frequency stability ±100 ppm
Environmental
Table 6. Environmental specifications
Operating temperature range 0 to 70 °C
Storage temperature range -40 to 70 °C
Humidity 0 to 95% non-condensing
Mechanical
Table 7. Mechanical specifications
Card dimensions PCI short card: 136.0 mm (L) x 100.6 mm (W) x11.00 mm (H)