Mega Catch MCU-800 Ultra - Manual (Page 20)

18
Your Mega-Catch™ Mosquito Trap comes with an External Skirt which fulfils two important
functions. First its color and texture provides a visual attractant for several species of mosquitoes.
Secondly, it acts as a baffle directing the air plume out of the bottom of the Trap.
There are two methods which you can use to fit the Skirt (Method One is the easiest):
Fitting of External Skirt
U.S. Design Patent No 449,091
Hook-and-loop fastening
External Skirt
FIG 6 - Fitting External Skirt
Method One:
1. Place the Mega-Catch™ Mosquito Trap on a table or other flat surface.
2. Slide the Skirt on from the top of the Trap (over 2 corners initially) with the elastic band
at the top.
3. The Skirt is properly fitted when the elastic band is seated over the lower horizontal
rib, just below the inlet holes (see figure 6). The opening in the Skirt should be located
at the front of the Trap so as to facilitate removal of the Door without having to remove
the Skirt. The hook-and-loop fastening on this opening should be closed when the Trap
is running.
Method Two:
1. Hang the Mega-Catch™ Mosquito Trap from the Stand (see Page 3 - Initial Setup
Instructions section - paragraph 11).
2. Slide the Skirt up from the bottom of the Trap (over 2 corners initially) with the elastic
band at the top.
3. The Skirt is properly fitted when the elastic band is seated over the lower horizontal
rib, just below the inlet holes (see figure 6). The opening in the Skirt should be located