beautypg.com

Using the configuration menu (continued) – D-Link DI-774 User Manual

Page 31

background image

31

Using the Configuration Menu (continued)

Advanced > Performance > 802.11a

DTIM interval-

(Delivery Traffic Indication Message) 1 is the default setting. A
DTIM is a countdown informing clients of the next window for
listening to broadcast and multicast messages.

RTS Threshold-

This value should remain at its default setting of 2346. If incon-
sistent data flow is a problem, only a minor modification should
be made.

Beacon interval-

Beacons are packets sent by the DI-774 to synchronize a wire-
less network. Specify a value. 100 is the default setting and is
recommended.

Data Rate-

Auto is the default se-
lection. Select from the
drop down menu for
your selection.

Wireless
Performance-

Select 802.11a or
802.11g. Here,
802.11a has been
chosen. This screen
displays the wireless
performance features
of the Access Point
portion of the DI-774.

Fragmentation-

This value should also remain at its default setting of 2346. If you
experience a high packet error rate, you may slightly increase
your Fragmentation value within the range of 256-2346. Setting
the Fragmentation value too low may result in poor performance.

Authentication-

Select Open system or Shared Key

Open System -

The DI-774 will be visible to all devices on the network. This is
the default setting

Shared Key -

In this mode, in order to access the DI-774 on the network, the
device must be listed in the MAC Address Control List

Transmit Power-

Full is the default selection. Select from the drop down menu for
your selection.

SSID Broadcast-

Choose Enabled to broadcast the SSID across the network.
All devices on a network must share the same SSID (Service
Set Identifier) to establish communication. Choose Disabled
if you do not wish to broadcast the SSID over the network.