MBM Corporation 352SA automatic air suction folder with Register System - Manual (Page 65)

Operator's Manual multimaster CAS 35 PBA
66 Mathias Bäuerle GmbH
N o . Possible Cause Remedy
10 Air brackets not set parallel Adjust air brackets according to scale
11 Gap between sheets is too narrow Increase sheet gap via BASIC menu
12 Pump not switched on Switch on pump
13 Suction drum is loose Tighten suction drum (3 Allen screws)
14 Timing belt pulley is loose Tighten timing belt pulley
15 Sheets are not fed at right angles Align angle of register rail
16 Sheets are not cut at right angles Adapt fold plate stop to the sheet by
adjusting the knurled screw
17 Fold plate stop not set correctly Readjust fold length via the BASIC menu
18 Change of fold speed Set regular speed via the BASIC menu
19 Distance between ejector rollers Increase distance via the BASIC menu
and hold-down rollers too short
20 Ejector rollers on knife shafts are Arrange ejector rollers evenly across
not distributed evenly across the paper width
paper width
21 Ejector rollers worn Replace rollers
22 Paper jam, safety system has Clear jam, switch the machine off
switched off the machine and then on again
000/01.02