MBM Corporation 5221-EC - Manual (Page 8)

IDEAL 4810-95 EP; IDEAL 4850-95 EP; IDEAL 5221-95 EP; IDEAL 6550-95 EP
8
03-01-10 B5221G2w.doc
Cutting to specified dimensions
- Enter dimension on the display (16)
fi LED "S" (25) appears.
- Press key fi dimension is approached,
LED "S" disappears.
Dimensions below 9 cm can only be
approached with the
key held pressed.
- Insert the paper and push it with the
Knocking-up block to the backgauge.
- Release the cut.
Programming is described under point 3.3
“programming”.
Cut according to markings
- Position the backgauge with the hand-wheel
(6) to the back.
- Insert the paper and push with the Knocking-
up block to the backauge (9).
- Turn rotary control (6) to the front until the
marking on the paper to be cut is below the
cutting line indicator. The more the rotary
control is turned, the faster the backgauge
moves. Return of the backgauge is only
possible in quick motion by turning the rotary
control to the left.
- Release the cut.
Eject function
If you press the key
¢
instead of , after
insertion of the dimension the backgauge
moves to the front for taking out the paper.
After that it goes to the adjusted dimension of
the figure field.
Repeat cutting
- Enter
dimension at numerical
keypad (16).
- Drive to dimension by activating the key.
- Push the paper to the backgauge (9).
- Press
M
key fi LED „M“ (24) is displayed.
- Enter repeat dimension.
- Press
key after cutting activation
fi Backgauge moves to the front by the set
amount of the repeat dimension entered.
Repeat dimension function completed
- Press
M
key fi LED "M" (24) switch off.
Cutting activation
s Danger!
- Run backgauge to the front for turning the
paper stack.
- Do not reach into the cutting area when
the blade is in motion.
You can only release a cut, if the specified
dimension was approached correctly.
fi The
LED "S" on the display has to be off.
- Close the guard (1).
- For model IDEAL 4810:
Before every cut the clamp should be lowered
by turning the hand wheel (26) to the right,
and tightened with light pressure.
- Press both buttons of the two-hand activation
(2) simultaneously and keep them pressed
until the paper is completely cut.
Cutting stop or interruption
- Release one or both buttons of the two-hand
control.