MBM Corporation 5221-EC - Manual (Page 13)

IDEAL 4810-95 EP; IDEAL 4850-95 EP; IDEAL 5221-95 EP; IDEAL 6550-95 EP
13
03-01-10 B5221G2w.doc
Blade mounting
- Turn resp. replace cutting stick. Bring the
blade carrier in the top position with the blade
adjusting screw (9).
fi see "Cutting stick
replacement".
- Place the blade to be exchanged with the
blade changing tool (4) mounted, into the
blade carrier (3) up to the top and screw it
into place with the grips.
- Lightly tighten 3 of the 5 blade screws (with
washers).
- remove the blade changing tool
- Lightly tighten the remaining blade screws
(with washers) (2).
- For model IDEAL 4810 and IDEAL 4850 the
blade screw (6) can only be inserted after the
blade has been lowered.
- Remove all tools and distribute paper along
the entire cutting length.
- Lower the blade by pressing both cut buttons.
Keep one button pressed and turn off the
main switch (5).
- The 3 eccentrics (1) should then be used to
lower the blade until the paper is cut along
the entire length of the blade (The blade must
remain parallel to the cutting stick).
- If needed, the blade can be lowered using the
blade depth adjustment screw (9) (Blade
must be in upper position).
fi See "Cutting test".
- For model IDEAL 4810 and IDEAL 4850
tighten the blade screw (6).
- Turn main switch (5) to position I.
- The blade will return to the upper position and
the blade screws should be tightened firmly.
- As described cut a stack of paper.
l Warning!
Blades may only be sharpened by
specialists.