MBM Corporation 5221-EC - Manual (Page 12)

IDEAL 4810-95 EP; IDEAL 4850-95 EP; IDEAL 5221-95 EP; IDEAL 6550-95 EP
12
03-01-10 B5221G2w.doc
4.2 Blade replacement
Despite correctly set cutting depth and new
cutting stick it is not possible to achieve a clean
cut
fi sharpen or replace the blade.
Blade demounting
s Danger!
The blade is very sharp. Do not dismount or
transport the blade without blade protection.
- Lower the blade by pressing both cut buttons.
Keep one button pressed and turn off the
main switch (5).
- The eccentrics (1) are now exposed and
should be turned to position 0 (special wrench
found in tool set).
- For model IDEAL 4810 and IDEAL 4850 the
blade screw (6) must be removed.
- Remove the special wrench and turn on the
main switch (5) until the blade returns to the
home position.
- Remove the 2 blade screws (2).
- Put the blade changing tool (4) into place and
fasten it to the blade.
- Screw out the remaining 2 respectively 3
blade screw.
- Loosen the grips of the blade changing tool
(4) lightly.
- Take the blade downwards out of the
machine.